ODIN Mag Dumper Lid Instructions

Written Instructions:

Tools needed

  1. Sharp blade (scalpel, box cutter, pocket knife, etc...)
  2. Phillips head screw driver

 

Instructions

  1. Undo the six screws using a phillips head screw driver and open the two halves.
  2. At the top of each by the softshell's opening flaps for the lid, use a sharp blade to cut as shown in the picture below in the red oval.The red circle identifies where the softshell needs to be cut to better accomodate the ODIN Mag Dumper Lid
  3. Remove original lid. It may have fallen out during disassembly.
  4. Reinstall the two softshell halves.
  5. Place the RUD Innovations ODIN Mag Dumper Lid in the closed position. Move the altered flaps out of the way to allow the lid to sit in its groove.
  6. While keeping the lid in its groove, put the two halves together. The half without the lid may have to have its altered flap nudged out of the way.
  7. Double check the lid is in its groves by holding the two haves together and open and close the lid.
  8. Reinstall the six screws.